Trunk VLAN across AP1240 wireless bridge

Unanswered Question
Feb 14th, 2007

I have an AP1240 set up as an access point at the main site and three AP1240 units set up to bridge traffic to the AP in just a LAN scenario. No routing.

The IP Address of the AP140 units is in the 10.10.10.0/24 subnet.

On the remote end of the wireless bridge units there are printers and workstations in the 10.10.20.0/24 and 10.10.30.0/24 subnets. All in a flat network using subinterfaces.

I want to VLAN this traffic and will have to trunk the different VLANs from the remote wireless bridge networks.

How would this be done?

Do I need to set up the wireless bridges to trunk these VLANs?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Wireless VLAN deployment is different for indoor and outdoor environments. For indoor deployments, the access point is generally configured to map several wired VLANs to the wireless LAN. For outdoor environments, 802.1Q trunks are deployed between bridges with each bridge terminating and extending as an 802.1Q trunk, participating in the 802.1d-based Spanning-Tree Protocol process.

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a00801444a1.html

Actions

This Discussion