Routing with 2801

Unanswered Question
Feb 14th, 2007

Hello, I am new to Cisco routers and I have a 2801 unit here I would like to setup for static routing. I have two firewalls, both Watchguard x core units. One is configured on a DSL connection, the other on cable. I want to route all traffic destined for 10.60.0.0 network through firewall A on the DSL, while all other traffic is routed through firewall B on the cable connection. Is this possible with the 2801 and where is a good place to start learning how to configure it to do so? Thanks!!!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion