02-15-2007 07:46 AM - edited 03-14-2019 08:03 PM
Hi,
i beleive i have read it somewhere on the forum before but i could not find it again.
I have CCM 4.13 and VG 2811 in SRST fall back.
Normal behavior, end user dials 9 for access code and hear tone as soon as he dials 9.
in SRST mode (i configured the access code 9 of course) it takes long time to hear back the tone and the end user feel something wrong (it could take like 7 seconds).
Is there any way to reduce this timing?
Good day
Solved! Go to Solution.
02-16-2007 07:49 AM
under the SRST config, can you try "secondary-dialtone 9" and see if that helps
02-16-2007 08:38 AM
The delay is because of the 9T configured in the Dial-peer. By configuring 9T, the system waits for the inter digit timeout. I think the default value is 10 second. Try the following:
Dial-peer voice 1 pots
Description Local Calls
destination-pattern 9[2-9].........
port 0/0/0
forward-digits 10
Dial-peer voice 2 pots
Description Long Distance
destination-pattern 91[2-9].........
port 0/0/0
forward-digits 11
This is an example for local and Long Distance calls. You need to configure a Dial-Peer matching the international calls as well.
02-15-2007 09:59 AM
sounds more like u have an overlapping Dialplan. Do a show dial-peer voice summary and check for the overlap. The best option is to aviod overlap instead of playing with timers
02-15-2007 12:03 PM
uhmmm,
well i have more than one dial peer with each point to an FXO (Voice port).
Dial-peer voice 1 pots
destination-pattern 9T
port 0/0/0
02-15-2007 12:21 PM
can u attach the output of "show dial-peer voice summary" and "show call-manager-fallback all"
02-15-2007 12:27 PM
Hi Mahesh,
I will send them tomorro as i have no access to my customer's remotly.
thanks Mate for your help
Good day
02-15-2007 11:05 PM
02-16-2007 07:49 AM
under the SRST config, can you try "secondary-dialtone 9" and see if that helps
02-16-2007 08:38 AM
The delay is because of the 9T configured in the Dial-peer. By configuring 9T, the system waits for the inter digit timeout. I think the default value is 10 second. Try the following:
Dial-peer voice 1 pots
Description Local Calls
destination-pattern 9[2-9].........
port 0/0/0
forward-digits 10
Dial-peer voice 2 pots
Description Long Distance
destination-pattern 91[2-9].........
port 0/0/0
forward-digits 11
This is an example for local and Long Distance calls. You need to configure a Dial-Peer matching the international calls as well.
02-21-2007 09:58 AM
The secondary dial tone did the JOB.
Thanks and Good day
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: