I need to schedule the reload of hundreds of devices for a scheduled reload. LMS2.6's RME is not cooperating. BTW, both the RME application and the RME device packages were up to date as of last week. I have been able to DL code, and actually distribute code quite reliably for the first time with this LMS 2.6 product. I was very pleased until... I can't schedule a reload. I noticed from the job results that RME's first response to a "[confirm]" prompt is to follow with a "y", which doesn't work with IOS Catalysts (I think it works with routers though). So after research, I find I need to do an "interactive ad-hoc".
Here is my simplistic ad-hoc.
reload at 05:00 17 Feb 2007<R>
That didn't work, so I thought maybe I needed two carriage returns...
reload at 05:00 17 Feb 2007<R><R>
Well, that didn't work, lets try "CR"
reload at 05:00 17 Feb 2007<CR><CR>
Nope, that didn't work either, the device I tested this against does still not have a scheduled reload.
Below are the "Successful" job results.
reload at 05:00 17 Feb 2007
Reload scheduled for 05:00:00 EST Sat Feb 17 2007 (in 36 hours and 33 minutes) by USERNAME-REMOVED on vty2 (10.10.0.102)
Proceed with reload? [confirm]
Based on the job results, it certainly seems successful. However, when I console to the device, I don't get that message after authentication, plus...
No reload is scheduled.
As a side note, I am surprised that RME no longer has a NetConfig task to schedule reloads, I could swear that the previous version of RME had such a defined task.
Can someone advise on this problem?