02-16-2007 12:24 AM - edited 03-05-2019 02:23 PM
Hi all,
I accedentally erase my bootflash, how can i intall th bootflash IOS, using flash disk, because i've seen usb connector on my router.
Regards,
Lester
02-16-2007 01:45 AM
Which router? and did you erase the ios image or the rommon (if that is possible).
02-16-2007 01:47 AM
hi,
i erase the IOS image, at 2800 series
02-16-2007 02:01 AM
I believe that USB support is available only when the ios is up and running. So your option is to get into rommon mode and tftp a valid image to flash.
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00801fc986.shtml
02-21-2007 09:33 PM
Lester, did you reload/power cycle the router after the IOS was deleted? If the router is still running and was not reloaded then you can copy it form a tftp server without having to relaod the router or going into ROMMON mode.
Software Upgrade Procedure
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide