cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
677
Views
0
Helpful
7
Replies

WIC

sameersharif
Level 1
Level 1

Can we use WIC card of 2610XM for 1721 Router

Thanks

7 Replies 7

CSCO10892433
Level 4
Level 4

Hi, sameersharif

Which kind of wic card do you mention? Wic-1t and Wic-2t are surely supported by both platform. Here is two links regarding this two types of card:

WIC-1T

http://www.cisco.com/en/US/products/hw/modules/ps3129/products_tech_note09186a00800b0859.shtm

WIC-2T

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b0858.shtml

If you are mention other types of card, it's no difficult to find a similar pages.

HTH

SSLIN

Thanks for ur reply

1. We are using 1721 CISCO router that has one WIC-1ENET CARD AND ONE WIC-2T, both the serial interfare are occupied, now we want one more serial interface

2. Is there any card available with both ethernet and serial port

Please advise

Sameer Sharif

Hi, sameersharif

So your needs is to have 3 wan connections and 2 lans? If so, I would suggest you to remove the wic-1enet and install one wic-1t instaed. Then you will have 3 wan ports for each connections and only one FE port for two lan subnets. Anyway you can create 2 subinterfaces on FE port that still meet your needs.

Let me know if this solve your problem.

SSLIN

spremkumar
Level 9
Level 9

Hi Shariff

You can make use of the WIC Card but make sure you are installing the same once you have switched off the 1721 router...

regds

Thanks for ur reply

1. We are using 1721 CISCO router that has one WIC-1ENET CARD AND ONE WIC-2T, both the serial interfare are occupied, now we want one more serial interface

2. Is there any card available with both ethernet and serial port

Please advise

Sameer Sharif

Hi Sameer

In this case you need to lookout for an upgrade of your router to higher version where in you can get required number of ethernet ports (i feel its 2) and required number wan ports.

AFAIK you can have both ethernet and serial ports accommodated only in NM modules which wont fit in Cisco 1721.

But its the other way around the same can be installed on your Cisco 2600 series router..

regds

Unfortunately, the options for the 2610xm are limited. You can have NM cards with 1 or 4 ethernet (10mb) interfaces or with WIC slots but not both.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: