Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
4409
Views
0
Helpful
1
Replies

isdn sending-complete -what does it do?

bradlesliect
Level 1
Level 1

‎02-16-2007 08:08 AM - edited ‎03-03-2019 03:47 PM

Hi,

Trying to figure out what it does and if it will solve a problem with ISDN users not being able to dial in?

At the moment analogue users are able to dial in and connect but the ISDN users get disconnected immediately.

We make use of a windows auth server which has been configured on the router.

Looking at cisco docs but not finding a solution ....not quick enough that is ...

Please help

Labels:
0 Helpful
1 Reply 1

ahmednaas
Level 4
Level 4

‎02-16-2007 08:37 AM

Here is with the manual says:

_____________________________________________

Configure the voice port to include the Sending Complete information element in the outgoing call setup message. This command is used in some geographic locations, such as Hong Kong and Taiwan, where the sending complete information element is required in the outgoing call setup message.

_____________________________________________

It seems to be an outgoing call setup command needed for some exchanges in the far east. So it is not likely to help in resolving your issue.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card