PRI from Carrier with inbound caller ID name+Number

Unanswered Question
Feb 16th, 2007

I have a CME 4.0 and we might be switching over to a PRI. The Carrier states they can send us the name and calling number for caller ID. Problem is I never seen a install where we displayed the person's name.

My question is can this be done. I did some research on cisco and found the following:

Analog FXO (loop & ground start), DID, E&M, BRI/PRI support (NI2, 4ESS, 5ESS, EuroISDN, DMS100, DMS250, and several other switch types currently supported in Cisco IOS Software), Caller ID, Automatic number identification (ANI), calling name

Does the last part mean as long as the carrier is sending us the calling partys name it will display it on the phones?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion