WLANS

Unanswered Question
Feb 18th, 2007

Hi all, if I have a wlan and I want to have different vlans within this, Do I just create vlans on my switches, and then does the wlan controller have ports I can plug into each of these vlans ? and If I wanted to route between them, would I just enabled ip routing on the switch ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rduke Sun, 02/18/2007 - 08:42

Create your VLANs on your switch,

Create the same VLANs on your access points/bridges

Connect AP or bridge to switch in dot1q trunking mode - this will pass all VLANs between the two.

Use layer 3 switch to route between VLANs.

SSIDs map to VLANs, VLANs map to whatever security you need per SSID/VLAN.

Randy

carl_townshend Mon, 02/19/2007 - 02:28

Hi there, cheers for that, would I have to use a trunk link to my wlan controller also ?

Actions

This Discussion