02-19-2007 11:24 AM - edited 03-18-2019 06:58 PM
I install cisco call manager 4.2 and is working properly,and have unity , but i do not know how install it for working (UM) Unified Messaging.
I need advice and a guide line for how to integrate it.
I have alrealy a Exchange 2000 and Controller domain in another server.
Could someone please point me to a step by installation and configuration guide for unity 4.2 for (UM) Unified Messaging.
Does Anyone can help?
02-19-2007 12:35 PM
Take a look at the following link.
Hope this helps. If so, please rate the post.
Brandon
02-19-2007 01:55 PM
You mean you have Unity installed as Voicemail only in it's own AD domain, seperate from your production domain. (Exchange email, etc)???
02-19-2007 04:22 PM
Hi, Actaully I have exchange local and AD domain in the same server, but need know as configured Unity for UM.
can you help me?
Thanks
02-19-2007 04:27 PM
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_white_paper09186a0080109775.shtml
read through this document and see if you have any questions.
02-19-2007 05:54 PM
U should follow the doc given earlier, for step by step information about how to go about with the install.
In simple,
Install Unity as a part of the same AD Domain as ur existing setup as a Member server (pref) and when u run Message Store Configuration Wizard, point it to your existing Exchange server.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: