Telnet into 4506 switch with only fiber ports

Unanswered Question
Feb 19th, 2007

Hi to all,

I just wanted to know that if I have all fiber modules in a 4506 switch and the only UTP port that I have is a 10/100 management port on the Sup II plus, then what can I do to connect my laptop to a switch, telnet into it and upgrade the image if the need be? Is it possible.

The reason is that none of the fiber ports are connected and hence i need to use in some way the management port.

Thanks a lot

Gautam

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
glen.grant Mon, 02/19/2007 - 14:55

If its hooked to a running network you would just telnet into , if it is just standalone uninstalled then you should be able to plug into that 10/100 mamanagent port and do it that way . You can also use the console port to configure the box to put an address and gateway on it if it needs that .

gautamzone Mon, 02/19/2007 - 21:28

Thanks a lot Glen.

But what are the steps to configure a management port on the Sup II Plus?

I dont see the management port in the running config or sh ip int brief.

Thanks a lot

Gautam

Actions

This Discussion