02-20-2007 12:21 AM - edited 03-03-2019 03:49 PM
I have a strange problem,
I have multiple ADSL Lines arround the country and
i have one static point on the Internet, so what i have done is i have used the static point as my spoke router and the "CORE" Adsl point as my junction point for the rest of the ADSL GRE tunnels to land.I am running multipoint NHRP and this works fine. After a while the site goes down but the GRE Tunnel stays up i just cant route the private network through the Tunnel unless i ping the other end
of the tunnel. Can auone suggest anything ?
02-20-2007 10:43 AM
Can you give us Some configuration , which you have configured both end.
Regards,
Dharmesh Purohit
02-21-2007 12:04 AM
Hi there
Static Point
interface Tunnel666
ip address 192.168.20.x 255.255.255.0
no ip redirects
ip nhrp authentication (word)
ip nhrp map multicast dynamic
ip nhrp network-id 1
ip ospf network broadcast
ip ospf priority 2
tunnel source Ethernet0/0
tunnel mode gre multipoint
tunnel key 1
tunnel protection ipsec profile p1
ADSL Core (Landing Point for Other ADSL)
interface Tunnel666
ip address 192.168.20.2 255.255.255.0
no ip redirects
ip nhrp authentication (word)
ip nhrp map 192.168.x.x 196.x.x.x
ip nhrp map multicast 196.3.x.x
ip nhrp network-id 1
ip nhrp nhs 192.168.20.x
no ip split-horizon
ip ospf network broadcast
ip ospf priority 0
keepalive 10 3
tunnel source Dialer1
tunnel mode gre multipoint
tunnel key 1
tunnel protection ipsec profile p1
ADSL Site (CPE)
interface Tunnel666
ip address 192.168.20.x 255.255.255.0
no ip redirects
ip nhrp authentication (word)
ip nhrp map 192.168.20.x 196.x.x.x
ip nhrp map multicast 196.x.x.x
ip nhrp network-id 1
ip nhrp holdtime 300
ip nhrp nhs 192.168.20.1
ip ospf network broadcast
ip ospf priority 0
keepalive 10 3
tunnel source Dialer1
tunnel mode gre multipoint
tunnel key 1
tunnel protection ipsec profile p1
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: