SRST issue

hujjat.fryback · ‎02-20-2007

Hello, I'm currently experiencing an issue with SRST. In an environment of about 160 phones 15 are in a SRST Device Pool (whose SRST refence is configured correctly..[IP for Gateway is correct, port is 2000 & Cert port is 2445]..). All phones seem to switch fine into SRST mode, but only one phone will receive calls/ring.

What is being used:

-2821 gateway

-CCM 4.1(3)

-7961 IP phones.

Any suggestions would be appreciated. Thanks.

carenas123 · ‎02-26-2007

what is your SRST gateway connected to , a T1 , check for the configuration of the controller.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_configuration_guide_chapter09186a00801f3b0a.html#wp1353626

hujjat.fryback · ‎02-26-2007

Thanks for the suggestion we finally figured it out. simple mistype problem in the Gateway configuration. all we needed was a day off and when we took a look at it again the problem was staring us in the face :)