Autoconfiguration Problems SupEngV 4506

Unanswered Question
Feb 20th, 2007

I cannot get past the autoconfig to manually setup my new 4506. The 'setup' command does not exist and I cannot assign an IP address to an interface. Chapter 3 "Config the Switch for the First Time" is of no use.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
kzachreson Wed, 02/21/2007 - 05:57

I am trying the configure the switch for initial installation. I inserted the SupEng, blades, and powersupplies and now need to set it up for use.

Actions

This Discussion