About Frame Relay

Unanswered Question
Feb 20th, 2007

I'm using a 6509 and need to enable frame-relay switching on the platform. However, after I set up the interface configuration, I canot find the "frame-relay route" command. I did enable "frame-relay switching" in the global configuration mode.

Thanks for your comment.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
philipsyao Wed, 02/21/2007 - 07:49

the corresponding information:

Adapter: "WS-X6182-2PA 2 port adapter FlexWAN Rev. 1.5"

Line Card: "Channelized DS3 - single wide, one port" PA-MC-T3

IOS version: 12.2(18)SXD2

My configuration:

controller T3 7/0/0

t1 1 channel-group 0 timeslots 1-24

t1 2 channel-group 0 timeslots 1-24

t1 3 channel-group 0 timeslots 1-24

t1 4 channel-group 0 timeslots 1-24

t1 5 channel-group 0 timeslots 1-24

t1 6 channel-group 0 timeslots 1-24

t1 28 channel-group 0 timeslots 1-24

interface Serial7/0/0/1:0

no ip address

no ip unreachables

encapsulation frame-relay IETF

no fair-queue

no arp frame-relay

frame-relay interface-dlci 34

What I'm planning to do is aggregate all the user data and management data from all teh sites through T1, terminate the user data(DLCI 34) and get the Authentication and get the ip address locally. Then switch the management data (DLCI 33) to another T1 (T1 28 in this case) which will be connected to the DSLAM Gateway for management.

purohit_810 Tue, 02/20/2007 - 15:34

Hi,

Can you give configuration and IOS name .... so we can conclude?

Reply ASAP.

Regards,

Dharmesh Purohit

Actions

This Discussion