Duplicate ethernet port on CCM5

Unanswered Question
Feb 21st, 2007

Hello,

I'm searching for a procedure to enable the both ethernet ports on the CCM5. By Default, the second ethernet port is inactive.

Thanks for your help

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
thisisshanky Wed, 02/21/2007 - 05:03

Plug both ports in to the switch.

From CLI of Callmanager type the following command,

set network failover enable. (You can use ? after each word for additional options).

HTH

Sankar

PS: please remember to rate posts!

mchandak Wed, 02/21/2007 - 07:07

Are u trying to use NIC Teaming ?? Remember, that NIC teaming is not supported on all CM 5.x versoin and HW. It would only work on HP servers with CM 5.0(4) and later

Actions

This Discussion