CCM4.2 & FXO problem

Unanswered Question
Feb 21st, 2007

I have CCM4.2 connected over mgcp & E1 PRI to PSTN. Every thing woks fine, but I elso have 6 FXO ports, and try to configure 5 of them to connect to 5 another analog phone lines. And all that I have is disconnect signal...

This is configuration of one of 5 FXO ports:

voice-port 3/0/8

signal groundStart

dial-type pulse

cptone RU

timing hookflash-out 500

caller-id enable

Can any one help me?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion