Trashed Firmware on WLC 2006

Unanswered Question
Feb 21st, 2007

I was doing an update on a 2006 WLC and after i uploaded the firmware and everything finished fine i saved the config and rebooted. Now i will not boot up and I cannot get into the Console port.

Does anyone know the type of cable needed and the serial port settings to get into the CLI via the serial port?

Additionally is there any way to fix this without RMAing the device?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode