OSPF problem

Unanswered Question
Feb 21st, 2007

Hi,

I am having problem with OSPF when I configured 1 to many VPN l2l tunnel "spoke to Hubs". I am getting an error when I wanted to add another neither in the OSPF statement " ERROR: Only one neighbor allowed on point-to-point interfaces".

Nortel Contivity work fine, I think they let pass the multicat in clear through the tunnel. We are testing the ASA to replace them but I have to fix this big issue. I don't want to use static route.

I found a document in Cisco site but no mentionon of OSPF on it:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00804675ac.shtml

Any idea or advice.

Thanks

Note:

I had no issue with OSPF when I configured 1 to 1 l2l tunnel using this document:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00804acfea.shtml

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
amritpatek Tue, 02/27/2007 - 10:49

This is a restriction on ASA 7.x, When an interface is configured as point-to-point, non-broadcast, You can define only one neighbor for the interface. Currently, only one neighbor is possible on an interface. In order to support multiple neighbors, point-to-multipoint support should be added.

nickbettison Thu, 10/09/2008 - 08:11

>In order to support multiple neighbors, point-to-multipoint support should be added.

Does anyone know if there is a bug/feature request for this, I see it's still not available in 8.0.4 :(

Actions

This Discussion