02-22-2007 02:16 AM - edited 07-03-2021 01:40 PM
Hello,
I have to configure a second AP as a repeater, and these are the steps that I done:
1- the 1st AP is working as autonomous AP
2- the seconde one i make it associated with the SSID of the 1st AP
3-I configured the roll of the 2nd AP as repeater
I think that this only are the steps to do it, as all the two AP are in standard configuration.
Is there any other step to do to configure the AP as repeater??
Solved! Go to Solution.
03-17-2007 10:47 PM
Hi omar,
Pls go through the below mentioed link.
http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo_350/accsspts/ap350scg/ap35ch12.htm
It may help you
Regds
Saji k.s
02-22-2007 06:07 AM
Hi Omar,
Here is a Step by Step guide that might help;
Configuring a Repeater Access Point
From this good doc;
Hope this helps!
Rob
02-22-2007 07:24 AM
Hello Rob,
This step are the same of what I did. But at the end the Repeater cannot associate to the AP ??
I'll try all the steps for a second time (after the weedend I'll do it) and I'll send you a reply if that will work.
Thank you anyway.
03-17-2007 10:47 PM
Hi omar,
Pls go through the below mentioed link.
http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo_350/accsspts/ap350scg/ap35ch12.htm
It may help you
Regds
Saji k.s
03-04-2007 02:20 AM
This is a part of the configuration file of the AP configured as a repeater :
(On the root, I have a default configuration with an SSID : DJEZZY Wifi Hotspot. unless I did all the steps, but I can't arrive to associate the Repeater to the root)
Note : the APs have all the default configuration.
CONFIG FILE:
Current configuration : 1218 bytes
!
version 12.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
dot11 ssid DJEZZY Wifi Hotspot
infrastructure-ssid optional
!
bridge irb
!
interface Dot11Radio0
no ip address
no ip route-cache
shutdown
!
ssid DJEZZY Wifi Hotspot
!
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role repeater
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface BVI1
no ip address
no ip route-cache
!
Regards,
Omar,
03-17-2007 12:58 PM
that guide is no help at all or my aironet 1242 is broken.
03-18-2007 06:28 AM
Do you have the same problem to configure a repeater??
You use what kind of security??
Can you post the part of the SSID ??
I have fixed my problem as I'm using Open Authentication.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide