BRI

Unanswered Question
Feb 22nd, 2007

People,

Troubleshooting isdn basic rates, any idea why a second bearer channel would not want to come up?

Checked the dial strings and config...cant see anything wrong..any suggestions?

Thanx in advanced.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
erniedavis Thu, 02/22/2007 - 13:04

You may want to verify the following commands in your configuration to bring both bearer channels up (these are entered in the interface command):

ppp multilink

dialer load-threshold load [outbound | inbound | either]

Hope this helps.

cisco_trouble Thu, 02/22/2007 - 21:52

yes, this is the 1st thing i checked, configs are correct. And on the telco side, what possible problems? Layer 2 comes up, but get a bearer channel error. 1st channel comes up.

spremkumar Thu, 02/22/2007 - 22:14

Hi

If possible can you post out the config as well as the exact error logs available out there.

regds

Actions

This Discussion