Cisco 11500 Series Content Switch - Host Header

Unanswered Question
Feb 22nd, 2007

I have a Cisco 11500 series content switch. I have a website that has multiple websites that use the same IP address but use host header to differenciate between the sites.

Can the content switch be configured to access a site by sitename (www1.xyz.com or www2.xyz.com) instead of by ip address?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
purohit_810 Fri, 02/23/2007 - 11:35

You can specify URL name by following configurations

config)# owner customer

(config-owner[customer])# content gzip

(config-owner-content[gzip])# vip address 192.168.77.40

(config-owner-content[gzip])# protocol tcp

(config-owner-content[gzip])# port 80

(config-owner-content[gzip])# url "/*"

(config-owner-content[gzip])# add service server3

(config-owner-content[gzip])# active

NOw if you would share load between the servers you can configure that by following command

" dnsbalance roundrobin "

There is also more options aslo. Deafault is round robin load balancing.

If you have any queries please get back to me.

We will again seat resolve the same.

Regards,

Dharmesh Purohit

Actions

This Discussion