What you are asking..... Multicast application in term of???
if you configure to multicast routing::::
Need following commands at least:
______________________________________________
FOR DENSE MODE ONLY
ip multicast-routing (Glocal configuration mode)
interface fastethernet (Interface in which you want to enable multicast)
ip address {IP address} {Subnet mask}
ip pim dense-mode
______________________________________________
IN PIM SPARSE MODE
ip multicast-routing (Glocal configuration mode)
ip pim rp-address {this is the router name} {IP address}
EX: ip pim rp-address 10.10.10.1
interface fastethernet0/0
ip pim sparse-mode
You can user either dense mode or sparse mode.
Also i am attaching documet for you.
Regards,
Dharmesh Purohit