Cannot see other computer name (LWAPP)

vivian4838 · ‎02-22-2007

We are using WLC4400(4.0.206) and LAP1130.

The network service is working well, but i cannot see other computer in the microsoft WinXP-SP2 network. They are same subnet.

I can search computer name in wired network but cannot see computer name in wireless lan(LWAPP)

I've enabled broadcast in WLC4400.(default value was disabled)

Is this LWAPP Turnnel problem?

a-vazquez · ‎02-28-2007

Make sure the connectivity is fine by checking the ping command.If you are able to ping check if DNS is configured properly

using dns-server command.Refer URL for more info

http://cisco.com/en/US/products/hw/wireless/ps4570/products_installation_guide_chapter09186a0080797e0d.html#wp1007837

eastman.rivai · ‎03-29-2007

hi it is piece of cake.

netbios is blocked by default thats why you can't browse computers

to solve the issue, follow the following instruction

enable multicast on controler general configuration and also on every ports that connected to the LAN.

sbhadrav@cisco.com · ‎03-28-2018

If your WLC mgt vlan is not DHCP enable, yes you can try manually configure an IP like below (IP & Gateway & WLC mgt IP info you have to change to according to your IP scheme). If CAPWAP keyword does not work uses LWAPP keyword in the command syntax

LWAP#debug capwap console cli

LWAP#capwap ap ip address 10.10.110.5 255.255.255.0

LWAP#capwap ap ip default-gateway 10.10.110.1

LWAP#capwap ap controller ip address 10.10.110.10

LWAP#debug lwapp console cli

LWAP#lwapp ap ip address 10.10.110.5 255.255.255.0

LWAP#lwapp ap ip default-gateway 10.10.110.1

LWAP#lwapp ap controller ip address 10.10.110.10

Refer this for more details

http://mrncciew.com/2013/03/17/ap-registration