02-22-2007 09:43 PM - edited 07-03-2021 01:41 PM
We are using WLC4400(4.0.206) and LAP1130.
The network service is working well, but i cannot see other computer in the microsoft WinXP-SP2 network. They are same subnet.
I can search computer name in wired network but cannot see computer name in wireless lan(LWAPP)
I've enabled broadcast in WLC4400.(default value was disabled)
Is this LWAPP Turnnel problem?
02-28-2007 12:32 PM
Make sure the connectivity is fine by checking the ping command.If you are able to ping check if DNS is configured properly
using dns-server
03-29-2007 08:38 AM
hi it is piece of cake.
netbios is blocked by default thats why you can't browse computers
to solve the issue, follow the following instruction
enable multicast on controler general configuration and also on every ports that connected to the LAN.
03-28-2018 12:54 AM
If your WLC mgt vlan is not DHCP enable, yes you can try manually configure an IP like below (IP & Gateway & WLC mgt IP info you have to change to according to your IP scheme). If CAPWAP keyword does not work uses LWAPP keyword in the command syntax
LWAP#debug capwap console cli
LWAP#capwap ap ip address 10.10.110.5 255.255.255.0
LWAP#capwap ap ip default-gateway 10.10.110.1
LWAP#capwap ap controller ip address 10.10.110.10
LWAP#debug lwapp console cli
LWAP#lwapp ap ip address 10.10.110.5 255.255.255.0
LWAP#lwapp ap ip default-gateway 10.10.110.1
LWAP#lwapp ap controller ip address 10.10.110.10
Refer this for more details
http://mrncciew.com/2013/03/17/ap-registration
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide