02-23-2007 03:30 AM - edited 03-11-2019 02:37 AM
Hello,
on a Cisco 836 CBAC is enabled on the inside Eth0 interface for incomming traffic. If on the outside interface BRI0 for ISP connection used all incomming ip traffic is blocked for returning traffic from initiated inside.
Is CBAC working with dynamic IP ?
Greetings
Peter from Lake Constance
02-24-2007 08:23 AM
Post a scrubbed config so we can see whats going on.
02-25-2007 11:40 AM
The CBAC works fine with dynamic IP.
Which version are you using ?
Which is the configuration ?
02-26-2007 07:41 AM
The fault was, I did not inspect the dialer0 interface out. So there was no dynamic ACLs open for returning traffic.
I inspect the eth0 out which is wrong.
This happens when you are used to checkpoint.
Greetings
Peter
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: