02-23-2007 06:30 AM - edited 03-14-2019 08:11 PM
I am working to try and solve an echo problem on a CM4.1 installation. Gateway is 2811 running 12.4(1r). I had echo cancellation enabled and was turning the coverage up a step at a time. Was also trying attenuation. Now when I "echo-cancel enable", it just doesnt show up in the run-config.
Beneath voice-port 0/0/0:23 there is just nothing. I get no error messages, but the enable command won't stick. Ideas?
02-23-2007 09:01 AM
If 'echo-cancel enable' is the default action, it may not appear in the config unless you enter another version of the command. i.e 'no echo-cancel enable'
If you show voice port 0/0/0:23 you should see 'Echo Cancellation is enabled'
02-23-2007 09:12 AM
Excellent, that was the case. I guess I didn't think about the fact that defaults don't show up. Thank you..
02-07-2014 01:15 PM
Hi,
I'm having the same problem on a new 2811 (12.4) with 4 FXS/DID ports. The show run of an existing 2811 (12.4) shows the parameter set to: echo-cancel coverage 64 under every voice port. However in building the new 2811 to work the same way, the echo-cancel coverage 64 doesn't show up... the echo-cancel enable command has been applied on each voice port individually but 'evidence' of the command doesn't show up in the show run...
Why is it that the exisitng 2811 does list the echo-cancel coverage and the new 2811 doesn't? How can the new 2811 be configured to list the same way?
Thank you!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide