VPN Tunnel stopped sending traffic

Answered Question
Feb 24th, 2007

Hi,

One of our VPN tunnels stopped sending traffic.. IS there any way where we can reset the tunnel again since i know that there were no config changes done on the tunnel

Thx

Shyam

I have this problem too.
0 votes
Correct Answer by kaachary about 9 years 7 months ago

Hi Shyam,

To clear the tunnel, you can do a :

On PIX :

clear cry isa sa

clear cry ipsec sa

On IOS :

clear cry isa

clear cry sa

HTH,

Rate if this helped !

-Kanishka

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Correct Answer
kaachary Sat, 02/24/2007 - 05:44

Hi Shyam,

To clear the tunnel, you can do a :

On PIX :

clear cry isa sa

clear cry ipsec sa

On IOS :

clear cry isa

clear cry sa

HTH,

Rate if this helped !

-Kanishka

dondongamo Mon, 02/26/2007 - 01:17

Hi,

Your answer is only applicable to a single tunnel. What if there are several tunnels and want to terminate specific tunnel w/o disturbing other live tunnels, is there any way we can point to specific SA id? or is it by way of clearing the specific vpn group? and what normally the time it takes to clear the SA id from the table and re-established the tunnel?

TIA

Actions

This Discussion