Is it possible to install SDM on old CISCO 2610?

Answered Question
Feb 26th, 2007

Hello all,

I have CISCO 2610 (not "XM" series) and NM4-E module for my labs. Is it possible to install SDM on it?

Extra info:

Bridgecom2610#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IPBASE-M), Version 12.3(9c), RELEASE SOFTWARE (fc 2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Tue 30-Nov-04 23:51 by kellythw

Image text-base: 0x80008098, data-base: 0x80F1D424

ROM: System Bootstrap, Version 11.3(2)XA2, PLATFORM SPECIFIC RELEASE SOFTWARE (f

c1)

Bridgecom2610 uptime is 1 hour, 59 minutes

System returned to ROM by power-on

System image file is "flash:c2600-Ipbase-mz.123-9C.bin"

cisco 2610 (MPC860) processor (revision 0x200) with 39936K/9216K bytes of memory

.

Processor board ID JAB0221001C (598769124)

M860 processor: part number 0, mask 32

Bridging software.

X.25 software, Version 3.0.0.

5 Ethernet/IEEE 802.3 interface(s)

4 Serial(sync/async) network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

Thank you!

I have this problem too.
0 votes
Correct Answer by Amit Singh about 9 years 7 months ago

Hello, its not supported on 2600 routers. Its only supported on 2600XM series.

http://www.cisco.com/en/US/products/sw/secursw/ps5318/prod_installation_guide09186a00803e4727.html#wp37069

HTH,Please rate if it does.

-amit singh

Correct Answer by hoogen_82 about 9 years 7 months ago

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet0900aecd800fa5be.html

SDM support seem to be only 2610XM routers.

I also checked up the software advisor, SDM support only on 2610XM not on 2610.

HTH

Hoogen

Do rate if i have helped :)

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.

Actions

This Discussion