Hello all,
I have CISCO 2610 (not "XM" series) and NM4-E module for my labs. Is it possible to install SDM on it?
Extra info:
Bridgecom2610#sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-IPBASE-M), Version 12.3(9c), RELEASE SOFTWARE (fc 2)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Tue 30-Nov-04 23:51 by kellythw
Image text-base: 0x80008098, data-base: 0x80F1D424
ROM: System Bootstrap, Version 11.3(2)XA2, PLATFORM SPECIFIC RELEASE SOFTWARE (f
c1)
Bridgecom2610 uptime is 1 hour, 59 minutes
System returned to ROM by power-on
System image file is "flash:c2600-Ipbase-mz.123-9C.bin"
cisco 2610 (MPC860) processor (revision 0x200) with 39936K/9216K bytes of memory
.
Processor board ID JAB0221001C (598769124)
M860 processor: part number 0, mask 32
Bridging software.
X.25 software, Version 3.0.0.
5 Ethernet/IEEE 802.3 interface(s)
4 Serial(sync/async) network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
Thank you!
