Possibility to schow all Rogue APs in the WCS Map

Answered Question
Feb 26th, 2007

Hi All, one Customer uses WCS 4.0.81.0 /w Location for Management. It seems to be not possible to show ALL detected Rogue APs on a Map, only one selected AP from the List. Is there a possibility to show all Rogue APs at on Map? Regards, Michael

I have this problem too.
0 votes
Correct Answer by claeysg about 9 years 7 months ago

Hello,

If you want to see all rogue AP at the same time, then you need the Cisco Location Appliance. WCS with license for location but without location appliance only allows you to locate one rogue AP at the time.

Rgds,

Gaetan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
MICHAEL SCHROEDER Tue, 02/27/2007 - 12:09

Hi akemp, the last time i saw it was on a WCS 3.2 Release, never in a 4.0. Did you? Regards, Michael

Correct Answer
claeysg Wed, 02/28/2007 - 02:10

Hello,

If you want to see all rogue AP at the same time, then you need the Cisco Location Appliance. WCS with license for location but without location appliance only allows you to locate one rogue AP at the time.

Rgds,

Gaetan

Actions

This Discussion

 

 

Trending Topics - Security & Network