Frame-relay switching using 2 routers

Unanswered Question
Feb 26th, 2007

I have 2 t1 CSU/DSU WIC card in cisco2800 and cisco2651 XM. This is my fisrt time doing this. Can you please specify which cable exactly I shd use:

Frame-relay switching is enbaled on both routers globally...

below is my config

interface Serial0/0

description FR switch

no ip address

encapsulation frame-relay

no keepalive

no fair-queue

frame-relay interface-dlci 201

!

interface Serial0/0.21 point-to-point

ip address 131.1.12.2 255.255.255.0

frame-relay interface-dlci 201

interface Serial0/3/0

description FR switch

no ip address

encapsulation frame-relay

no keepalive

frame-relay lmi-type cisco

frame-relay intf-type dce

!

interface Serial0/3/0.12 point-to-point

ip address 131.1.1.1 255.255.255.0

frame-relay interface-dlci 101

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
wordworship Mon, 02/26/2007 - 07:22

Thanks for your help.

The interface is still down. I am using a xover cable between both router and it is till not working....

ahmednaas Mon, 02/26/2007 - 07:54

Which csu/dsu are you using? Did you configure the controller correctly?

I suggest you tray to get the T1 link working first and then change encapsulation to FR.

Actions

This Discussion