02-26-2007 01:21 PM - edited 03-14-2019 08:13 PM
We have successfully created Translation Patterns based on the last 4 digits of the DID number. One of the DID numbers is 555-9126. For incoming calls, this works just fine.
We just tried to dial out to 91262XXXXXXX in the 262 area code and the Translation Pattern immediately kicks in after dialing 9126 and the call is routed internally and never goes to the external number.
How do we get CCM to wait until the entire number is dialed before applying the translation pattern?
Solved! Go to Solution.
02-26-2007 01:49 PM
One solution would be to put this translation pattern in a separate partition. Give the incoming gateway a calling search space which contains the partition and leave the partition out of the calling search space used by phones. This will allow incoming calls to hit the translation pattern and outgoing calls to bypass it.
Hope this helps. If so, please rate the post.
Brandon
02-26-2007 01:49 PM
One solution would be to put this translation pattern in a separate partition. Give the incoming gateway a calling search space which contains the partition and leave the partition out of the calling search space used by phones. This will allow incoming calls to hit the translation pattern and outgoing calls to bypass it.
Hope this helps. If so, please rate the post.
Brandon
02-26-2007 04:50 PM
You could also change your prefix digit. Use a 7 instead of a 9. Could save you from 911 misdials later on too.
02-28-2007 05:42 AM
We thought about that when we did our initial rollout, but decided against it. We are able to monitor 911 calls and our people have been surprisingly careful. Thanks for the suggestion!
02-28-2007 05:38 AM
We created a separate partition and it works great! Thanks for that suggestion!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: