EAP-PEAP AUTHENTICATION

akobwaycct · ‎02-28-2007

hi

am using CISCO ACS SE to authenticate my users who connect to my wireless network from the microsoft AD..am using EAP-PEAP.

the authentication works fine the problem is that after authenticating and associating my Client connects for about 5 minutes and reconnects again and it does this continously in intervals of 5 minutes..whare could i have gone wrong.

ebreniz · ‎03-06-2007

I don't think there is any issue with the authentication server unless you have set the client session interval to as low as 5 mins. Could you check what is the client session interval configured? Does it happen to all clients?

akobwaycct · ‎03-06-2007

yes it happens to all clients...where exactly do i check the client session interval in the ACS or WLC.

Vivek Santuka · ‎03-08-2007

Hi,

On the ACS->Group Setup Select Radius IETF Attribute 27 - Session Timeout - and set it to a high value.

Regards,

Vivek