Need PBR help

i-chowdhury · ‎02-28-2007

Hi!

I have 2 outgoing interface, one through serial interface (primary route) and another through VPN Tunnel. I am running ospf. In order to maximize the use of VPN Tunnel, I have seggregated some application going through VPN Tunnel using a route map statement. Now the problem is my outgoing traffic is taking the path of VPN but incoming traffic taking the path of serial interface. Is there any way I can influence the route map seggregated incoming traffic to take the take the same interface path using ospf?

Thanks in advance.

royalblues · ‎02-28-2007

you would need a PBR for these subnets at the other end as these subnets will be advertised by OSPF over the primary route.

Configure a route-map policy on the other side and point it to the VPN

HTH, rate if it does

Narayan

i-chowdhury · ‎02-28-2007

Hi! thanks for your quick reply. I forgot to mention that my both interfaces landed on different places (e.g. vpn landed on US, Serial landed on SG), do i need to create a route map for both of the end? what will happen to the outbound if one link fails? Does setting both ip next-hop will redirect the traffic during fallback?

Thanks again.