CISCO Works

Unanswered Question
Feb 28th, 2007

when trying to poll the start up configuring using LMS version 2.6 it gives a partiual suucess message. Where the error is showing as

CM0208: user not authorized to perform the opertaion on device.

but i have provided the telnet password and enable password as the credentials. (wich are correct) but still its providing me with the same error message. Please advice.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
David Stanford Wed, 02/28/2007 - 07:16

Can you check the following:

Common Services->Server->Security->Multi-Server Trust Management->System Identity Setup

Is the System Identity user configured?

Is there a file named "comUser.dat" in ?

Is LMS integrated with ACS?

mmssandhu Sun, 03/04/2007 - 22:17

thanks....the error was coming because i did not provide the credentials of telnet password and enable password on my core switch device....and all my edge switch is connected to the core switch.

But still i have some problem with one of the switches again ...when i try to fetch the configuration..it gives me partial success. The error that shows me is that it was not able to archive....please advice...thnaks for the eariler one..

Actions

This Discussion