Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
459
Views
0
Helpful
1
Replies

PoE on Cat 4510

londint
Level 1
Level 1

‎02-28-2007 05:07 AM - edited ‎03-05-2019 02:37 PM

We are connecting up PoE modules into a new 4510. Is there any thing I need to do or know before I power this up?

Thanks

Labels:
0 Helpful
1 Reply 1

Amit Singh
Cisco Employee
Cisco Employee

‎02-28-2007 10:51 AM

Please check which power supply you are using. You should have enough power to support POE on the devices that you are going to power up. Please use Cisco power calculator to check out the proper power allocation to the connected devices.Another thing to check for the minimum and recommended IOS for the modules you are trying to put in the chassis.

http://www.cisco.com/go/powercalculator

HTH,Please rate if it does.

-amit singh

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card