cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
370
Views
0
Helpful
2
Replies

7920 auth failed -though verified ssid & encypt. correct

jherder78
Level 1
Level 1

we have two 7920's and seen that we could not get them to authenticate to AP though both ssid and the encryptions on both the 7920 & AP were correct.

both phones could not authenticate and all settings were correct.

it wasn't until we reset the phones to factory defaults and re-keyed all settings then we could auth to AP.

any suggests as to why such occured ??

strange....

2 Replies 2

migilles
Cisco Employee
Cisco Employee

Sounds like a config issue.

Was it ever working? Did you upgrade/downgrade phone firmware?

Which authentication/encryption is used?

we thought the same, but it was working fine. for the time that we used them and there was no upgrade, using latest firmware.

The thing I failed to say was that we had left the phone's go dead, and needed to re-charge them before usage. <-after recharge was when we saw them unable to authenticate or authenticate failed. we could only use them after resetting them to factory defaults and re-keying the configs.

authentication wep 128 bit,w/ with un-broadcasted ssid

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card