ezpn with 877 for remote and 2800 for server

Unanswered Question

I have configured Ezvpn with 877 for remote site and 2800 for server. 877 is connected to internet over adsl.

877 can establish ezvpn session to server succesfully but when I tracroute from 877 to internet it goes through adsl network instead of vpn. I think the first hop should be my ezvpn server.

I check the ezvpn connection by

sh ip route


sh crypto ipsec client ezvpn

and sh crypto ipsec sa

and i am sure that vpn is established.

I also test all modes ( client and netw ext and network ext plus). it is same for all

Thanks in advance for your help

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ggilbert Thu, 03/01/2007 - 14:08

Do you have split tunneling enabled?

If split tunneling was enabled, you will have an acl underneath the group configuration.

You would see this if split tunneling was enabled.



Rate this post, if it helps!!


This Discussion