mac filtering configuration

axfalk · ‎03-01-2007

We need to configure a mac filter on a bunch of the cisco 2950 switches to allow only certain devices in. Short of manually doing it, has anybody done this in a more efficient way?

thanks

abhishek_nandavat · ‎03-01-2007

Hi,

What I understand is that you want only specified devices to be on your network, isnt it?

Well, what you can do is define a mac address based access control list and then apply a vlan-map to block or pass the traffic from those mac addresses.

Have a look at the following link for more -->

http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_example09186a0080470c39.shtml

The following URL might help as well -->

http://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_guide_chapter09186a008007fa38.html#1020942

Hope this helps...

Regards,

AbhisheK

Please rate helpful posts!!!

IWAN HOOGENDOORN · ‎03-02-2007

I think that 802.1x will help you ...

I think what you want is to either block specific devices to access a switch/network right?

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################