Blade Switch - Layer 2 Trunk Failover

Unanswered Question

Does anyone know from experience on a 3020 or GESM HP blade switch if downstream ports are recovered automatically when an uplink port recovers from a failure? I have seen references to the downstream ports being put in err-disabled state and was curious if they needed to be recovered manually even after the upstream recovers. Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
kcoley Wed, 03/07/2007 - 17:14

Yes, the downstream ports come up automatically when the upstream ports come back active.

Actions

This Discussion