E1 Controller not showing up in config

Unanswered Question
Mar 2nd, 2007

I have a new 3825 running c3825-ipvoicek9-mz.124-4.XC4.bin as recommended by cisco for using 7931 phones, I have a VWIC2-1MFT-G703 card installed, "1 Channelized (E1 or T1)/PRI port" shows up in the "show ver" command, however there is no controller in the config, also i am unable to configure isdn switch-type, commands for controller and isdn switch type are unrecognised, any ideas anyone ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
mark_gardner Fri, 03/02/2007 - 02:50

Thanks AT

I have already configured the card, penny eventually dropped.

Job done.

Thanks for help

Actions

This Discussion