Callmanager Express integration with Ericsson BP-250

juan.saez · ‎03-02-2007

Hi,

I have a Callmanager Express ver 3.3 and I need to integrate it with a Ericsson BP-250 through 4 isdn basig qsig. I am able to integrate it through a PRI Qsig but when I try to do that with basics the interfaces never go up.

This is the configuration:

interface BRI0/0/0

no ip address

isdn switch-type basic-qsig

isdn protocol-emulate network

isdn point-to-point-setup

isdn incoming-voice voice

isdn T310 120000

!

The router is a 2811. The led card never are turn on.

Thanks a lot.

Best regard.

Stoyan Stoitsev · ‎03-02-2007

interface BRI0/2/0

***

isdn protocol-emulate network

isdn layer1-emulate network

isdn incoming-voice voice

isdn send-alerting

isdn sending-complete

isdn static-tei 0

isdn skipsend-idverify

line-power

***

Check your cables!

juan.saez · ‎03-02-2007

Thanks, It work perfect.

Stoyan Stoitsev · ‎03-02-2007

I'm glad it helped.

Regards

paolo bevilacqua · ‎03-02-2007

Just a nitpick, you probably don't need "line-power". That is only necessary to power ISDN phones that have no power supply of their own.