ASA 5540 Failover

Unanswered Question
Mar 2nd, 2007

I have configured Active/Standby ASA 5540 failover. I cannot make the primary to be active for long it fails over to secondary after sometime.

I tried reloading seconday(active) it fails over to primary but after sometime it again failover back to secondary. All the connectivty seems to be OK

(interface, failover/stateful lan link)

see the attachment for config

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
vitripat Fri, 03/02/2007 - 04:14

syslogs would be very helpful in order to pin-point the reason as to why Primary PIX is failing over to secondary repeatedly.

Is it possible to look at the logs?

Regards,

Vibhor.

Actions

This Discussion