cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1100
Views
0
Helpful
3
Replies

SNMP not working properly

kmeraj
Level 1
Level 1

Since i have upgraded my 7206 NP GE router all NMS have stopped working for this router.

Show snmp reading which are continuously increasing, but NMS says SNMP time out.

what is wrong?

All snmp community / ACLs are same.

MRTG/NNM have stopped working for this router. Any idea,

Is there any configuration difference between IOS 12.3(2)T and below?

Waiting for response

KM

3 Replies 3

schakra
Level 1
Level 1

run #debug snmp packets

you will find some messages & may find out the reason.If not past the messages in the forum for further analysis.

Regards,

Sourav

after turning on

Debug snmp packets it has the following output. Any idea?

mulfan#debug snmp packets

Mar 3 15:59:54.437 PST: SNMP: Packet received via UDP from A.B.C.D on Serial1/0

Mar 3 15:59:54.441 PST: SNMP: Get request, reqid 1806968397, errstat 0, erridx 0

ciscoMemoryPoolEntry.6.1 = NULL TYPE/VALUE

ciscoMemoryPoolEntry.5.1 = NULL TYPE/VALUE

sysUpTime.0 = NULL TYPE/VALUE

system.5.0 = NULL TYPE/VALUE

Mar 3 15:59:54.445 PST: SNMP: Response, reqid 1806968397, errstat 0, erridx 0

ciscoMemoryPoolEntry.6.1 = 667573812

ciscoMemoryPoolEntry.5.1 = 184903596

sysUpTime.0 = 88139615

system.5.0 = mulfan

Mar 3 15:59:54.453 PST: SNMP: Packet sent via UDP to A.B.C.D

SNMP packet debugging is on

It seems that router is sending snmp packet.

However it need to be checked that snmp port(161 usually) with the nms is communicating or not.

Configure & run nbar protocol discovery

you'll find input & output column protocol wise.

Both input & output for snmp should increase

you can also check from ip accounting

whether nms & router communicating through snmp

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: