Incoming calls get fastbusy from h323 ATA to IP PHONe

Unanswered Question

I NEED FOR HELP GUYS!!!!PLEASE

I have the following scenario.

When I call from telefono DN:9510 attached to h323 ATA through the h323 IOS Gateway to CallManager at IP PHONE DN: 9002.

The IP PHONE rings but as soon as I pickup the PHONE, I get a fastbusy tone.

I ran some debug:

1. debug voip ccapi inout, and it showed the disconect cause code is 47.

2. show h323 gateway, it gave the same code disconect.

I was looking on Cisco web I couldn?t fine any informacion.

THANK VERY MUCH IN ADVANCE

REGARDS

WALTER

Attachment: 
I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rhugo Sun, 03/04/2007 - 06:28

Please post your config for your H323 gateway. It appears that the call is using the same dial-peer for incoming AND outgoing call legs. You might want to try separating that part first by adding a separate dial peer for the outgoing call leg.

Actions

This Discussion