03-04-2007 02:31 AM - edited 03-03-2019 04:01 PM
Hi All ,
My ospf router is showing that it is in INIT state & not forming FULL state , how should i fix the problem.
03-04-2007 02:39 AM
There could be many reason it is in INIT state and need lots of information. However, you can try this link on troubleshooting OSPF. Check the INIT part.
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a00800949f7.shtml
http://www.cisco.com/application/pdf/en/us/guest/products/ps6629/c1161/cdccont_0900aecd80310f6a.pdf
03-05-2007 01:55 AM
Hi,
for ospf to form adjacency you have to be sure of these parameters:
hello timers
hold timers
MTU size
area
authentication (if configured)
these parameters should be same in both routers to form adjacency.
07-21-2007 04:15 AM
Hi ,
Is there any command for checking the parameters configured in OSPF.
07-21-2007 05:08 AM
Hi,
Try:
sh ip ospf neighbor
Then use the interface to do:
sh ip ospf interface
P.S The document provided by Danilo is very useful.
HTH,
Mohammed Mahmoud.
07-21-2007 05:11 AM
Show ip ospf ----
show ip ospf interface
show ip protocols
The above commands should be able to give you all the parameters
http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/iprrp_r/ip2_s3g.htm
HTH, rate if it does
Narayan
07-24-2007 01:28 AM
Please remember that also the "stub" flag must match between interfaces in the same area.
07-30-2007 10:29 PM
give the ospf network type in interface
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: