I have a Cisco 3745 router with a ATM DS3 port adapter. I need to install a DS3 link to the peer end router which is a CISCO 7604 router.
Please find below the Show diag output of that 7604 device.
xxxx>sh diag
Slot 2: Logical_index 4
4-subslot SPA Interface Processor-200 controller
Board is analyzed ipc ready
HW rev 1.3, board revision A0
Serial Number: JAE10349NS3 Part number: 73-8272-10
Slot database information:
Flags: 0x2004 Insertion time: 0x20204 (22w2d ago)
Controller Memory Size:
832 MBytes CPU Memory
191 MBytes Packet Memory
1023 MBytes Total on Board SDRAM
IOS (tm) cwlc Software (sip1-DW-M), Version 12.2(18)SXF3, RELEASE SOFTWARE (fc1)
SPA Information:
subslot 2/0: SPA-2XT3/E3 (0x40C), status: ok
Slot 3: Logical_index 6
2-subslot Services SPA Carrier-400 controller
Board is analyzed ipc ready
HW rev 2.0, board revision A0
Serial Number: JAB103303N0 Part number: 73-9081-09
Slot database information:
Flags: 0x2004 Insertion time: 0x20B38 (22w2d ago)
Controller Memory Size:
248 MBytes CPU Memory
8 MBytes Packet Memory
256 MBytes Total on Board SDRAM
IOS (tm) cwlc Software (smsc-DW-M), Version 12.2(18)SXF3, RELEASE SOFTWARE (fc1)
SPA Information:
subslot 3/0: SPA-IPSEC-2G (0x3D7), status: ok
subslot 3/1: SPA-IPSEC-2G (0x3D7), status: ok
xxxx>
Please advise me if this 7604 device will support the DS3 link, as iam not very sure what these SPA Interface processor modules can do on these 7604 devices.
Also, there is a serial2/0/1 free on that 7604 device. If the hardware supports, can I terminate the DS3 link from 3745 ATM DS3 port adapter into this serial interface?
Appreciate your response.
Regards
Navneet
