Qos Problem for G.HSDSL

Unanswered Question
Mar 4th, 2007

Here is my running-config file. I run

"CANTAS(config-if-atm-vc)#service-policy output SES" command under PVC 0/35. After this command i dont take any error messages. But this service doesn't work.When I check running-config again i can not see this command under pvc. And i run "show policy-map interface atm 0/0.1" but see nothing. How can i start this service correctly. Thank for everthing.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paul_alexander Sun, 03/04/2007 - 22:53

Your ATM interface doesnt have the right configuration for a service-policy

Under the PVC you need to apply L2 QoS. Specify cbr or vbr for the interface speed.

The other thing that may be stopping you is the "atm route-bridge ip". I'm not entirely sure if that makes a difference. But if it still doesn't work then you will need remove that statement and get the remote end to adjust its configuration too.

Actions

This Discussion