Duplex set to Full with speed 10?

Answered Question
Mar 5th, 2007

Hi,

Is it possible to set a port on a cat os to duplex full\speed 10 that is connected to a Ethernet interface on a router with duplex set to full. I'm experiencing latency connecting over my WAN. I want to replace the Ethernet with FE but in the mean time i'd like to set it up as duplex full. when i try to set port duplex full on the switch it says its in autosensing mode and stays at half.

Any idea?

I have this problem too.
0 votes
Correct Answer by Danilo Dy about 9 years 6 months ago

If the port is 10/100BaseT, yes you can configure it to 10BaseT/Full-duplex

SW1: (enable) set port speed 4/1 10

Port(s) 4/1 speed set to 10Mbps.

SW1: (enable) set port duplex 4/1 full

Port(s) 4/1 set to full-duplex.

SW1: (enable)

4/1 disabled 1 full 10 10/100BaseTX

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Danilo Dy Mon, 03/05/2007 - 06:24

If the port is 10/100BaseT, yes you can configure it to 10BaseT/Full-duplex

SW1: (enable) set port speed 4/1 10

Port(s) 4/1 speed set to 10Mbps.

SW1: (enable) set port duplex 4/1 full

Port(s) 4/1 set to full-duplex.

SW1: (enable)

4/1 disabled 1 full 10 10/100BaseTX

Actions

This Discussion